Victron Energy
Smart Battery Sense
Smart Battery Sense is a wireless battery voltage and temperature sensor for Victron MPPT Solar Chargers. With voltage and temperature sense in place, batteries will be better charged; improving charging-efficiency and prolonging battery life. Both for lead, and for lithium batteries.
Smart Battery Sense Read More »
Skylla-i remote on-off cable
The Skylla-i remote on-off cable controls the on-off switching of the Skylla-i.
Skylla-i remote on-off cable Read More »
Rubber bumper for IP65 Charger
The IP65 Charger is already protected against dust, and water spray – now you can protect it from accidental damage too. This rubber bumper allows it to withstand the knocks and bangs of workshop life. It will extend the life of your charger, and it has an easy-carry handle, …or hang it from a hook
Rubber bumper for IP65 Charger Read More »
Pre-Charge Cable
The Pre-charge Cable allows internal capacitors of an inverter, inverter/charger or MPPT to be pre-charged via the DC terminals before connecting the battery. This method ensures that connecting the battery will not result in arcing at the connection point.
Orion-Tr DC-DC Charger Isolated remote cable
In the Orion-Tr Isolated DC-DC Chargers the remote on/off circuit is referenced to the primary battery (e.g. starter battery). The Orion-Tr DC-DC Charger Isolated remote cable is intended for applications where the remote on/off signal is referenced to the secondary battery (e.g. lithium battery with BMS).
Orion-Tr DC-DC Charger Isolated remote cable Read More »
Non-inverting remote on-off cable
Use this cable to connect the following products to the VE.Bus BMS:– Skylla-TG all models The cable translates the remote on/off driver logic from the VE.Bus BMS (normally high, and open circuit in case of alarm) to the logic needed by above products: active pull down to switch off.
Non-inverting remote on-off cable Read More »
MPPT Wire Box – Tr
The MPPT WireBox provides an extra level of safety, and is particularly useful if your MPPT Solar Charger is installed in a general access area. It covers all DC terminals, preventing accidental or inquisitive contact with terminal screws. There are various sizes available:MPPT WireBox-S 75-10/15MPPT WireBox-S 100-15MPPT WireBox-S 100-20MPPT WireBox-M 100-30/50 & 150/35MPPT WireBox-L Tr
MPPT Wire Box – Tr Read More »
MagCode Power Clip
with 30A ATO fuse The MagCode Power Clip is an accessory of the Blue Smart IP65 Charger with DC connector. This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
MagCode Power Clip Read More »
M6 and M8 Eyelet Connector
The M6/M8 eyelet connector with fuse is an accessory of the Blue Power & Blue Smart IP65 Charger with DC connector. Blue Smart IP65 Chargers This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
M6 and M8 Eyelet Connector Read More »